The Camera Positioning Cutting Control Process

Before start cutting, make sure the camera is on top of the first mark, click Mark first in the tab Manual of System Work Plat to save the current position of the camera. In subsequent jobs, the camera will start searching for the first mark from the saved position.

NOTE

Do not forget to update for new jobs or same jobs in different positions.

If Back Mark is checked, the camera will go back to the saved position automatically after cutting. Or you can click Back Mark to send the camera back by yourself.

The processing control functions are grouped in Laser Bar at the bottom of the software.

Click Start to start cutting, click Pause/Continue to pause and again to continue, click Stop to stop.

If the option Output select graphics is checked, the laser will cut only the selected paths.

If the option General cutting is checked, the laser will start cutting without the camera positioning, in Absolute coordinate or Current Position.